Component TE-200 with Tylan


Component TE-200 with Tylan 100ct Box

Elanco - Recommended for use in feedlot steers and heifers for increased rate of weight gain and improved feed efficiency.

Implant guns must be purchased separately!


Finishing implant, used for steers and heifers in confinement for slaughter, increases rate of weight gain and improved feed efficiency. Contains trenbolone and estradiol in a slow-release delivery implant. To be administered 80 to 90 days prior to slaughter for optimum performance.

Species: Beef cattle and calves and dairy calves


Antibiotic helps reduce injection site infections.

Easy to implant

Contain a slow-release agent

Improves efficiency of feed

Increases weight gain rate


Contains 20 mg estradiol and 200 mg trenbolone acetate (TBA) with 29 mg tylosin tartrate.

Not for use in dairy animals or animals intended for subsequent breeding.

Do not use in veal calves or animals intended for breeding.

A withdrawal period has not been established in pre-ruminating calves

Refrigeration required 2° to 8°C (36° to 46°F) and shield from sunlight. Discard open foil pouches.


  1. Load the implanter following the instructions supplied with each implanter. Restrain the animal with a squeeze chute and head restraint to increase the speed of implantation and keep the handler safe.
  2. Prepare the implant site by scrubbing the back side of the ear with a clean piece of cotton that has been soaked in a topical germicidal solution. The full contents of one cartridge cell should be implanted beneath the skin on the back side of the middle one-third of the ear. The location for insertion of the needle is a point toward the tip of the ear at least a needle’s length away from the intended deposition site. Avoid injuring the large arteries, veins and cartilage of the ear.
  3. With one hand, firmly grasp the ear. With the other hand, insert the needle point through the skin and ease forward on a lateral plane until the entire length of the needle is under the skin. Squeeze the trigger fully and withdraw the implant gun.
  4. Clean the implanter needle with alcohol or a properly diluted germicidal solution prior to implanting the next animal.



Specific References

related products